Suzuki Jimny Gen 4 (3-Door) Rock Sliders

Jimny 3 Door Rock Sliders

Des Sol Jimny 3 door rock sliders provide genuine sill protection for the Suzuki Jimny Gen 4. Manufactured from ASTM A106 carbon steel, they help guard the lower body against rocks, banks and other obstacles encountered on demanding terrain.

Each slider weighs approximately 13kg. In addition, reinforced mounting points provide dependable support while the integrated steps make it easier to enter the vehicle or reach roof-mounted equipment.

Key Rock-Slider Features

• Manufactured from ASTM A106 carbon steel
• Designed for the three-door Jimny Gen 4
• Approximate weight of 13kg per slider
• Reinforced vehicle mounting points
• Protection for the lower sills and body edges
• Convenient integrated side steps
• Vehicle-specific bolt-on installation
• No cutting, drilling or welding required
• E-coated and powder-coated finish
• Supplied as left- and right-hand sliders

Dependable Sill Protection

The Suzuki Jimny rock sliders run below the vehicle’s side sills, where they help shield vulnerable bodywork from off-road contact. Consequently, rocks and banks are more likely to contact the slider before reaching the sill itself.

The reinforced mounting system supports the slider without relying on thin cosmetic body panels. Therefore, impact forces pass through the intended vehicle mounting locations.

However, no slider can prevent every form of vehicle damage. Drivers should still approach rocks, banks and steep breakovers carefully.

ASTM A106 Carbon Steel

Des Sol manufactures the Jimny sill protection from ASTM A106 carbon steel. This material provides a strong foundation for the slider body, reinforced mounts and integrated step.

The three-door pair has an approximate combined product weight of 26kg. Therefore, owners should consider the added weight when calculating the vehicle’s payload and accessory load.

Integrated Side Steps

An integrated step runs along each rock slider. As a result, occupants gain a useful standing surface for entering the lifted vehicle and reaching accessories mounted above the cabin.

For example, the step can assist when loading a roof rack, adjusting an awning or reaching touring equipment. Always maintain secure hand support when standing on the step.

Bolt-On Installation

The three-door Jimny side steps use a vehicle-specific bolt-on mounting system. Therefore, standard installation does not require drilling, cutting or welding.

Professional installation is still recommended. The installer should position every bracket correctly and tighten the fasteners to the required torque.

Furthermore, check the mounting hardware after the first off-road trip and during regular vehicle servicing.

E-Coated and Powder-Coated Finish

The rock sliders receive an E-coated and powder-coated finish for lasting protection. The combined coating helps guard the ASTM A106 carbon steel against moisture and outdoor exposure.

Nevertheless, clean the sliders after mud, sand, salt or coastal travel. Also, repair deep scratches and coating damage promptly to maintain the protective finish.

What Is Included

• Left-hand three-door rock slider
• Right-hand three-door rock slider
• Integrated side steps
• Reinforced mounting brackets
• Required installation hardware

Important Fitment Information

These rock sliders are designed for the shorter three-door Suzuki Jimny Gen 4. They are not a direct fit for the longer five-door model, which requires its own correctly sized slider set.

The sliders should not be used as vehicle lifting or jacking points unless Des Sol specifically confirms an approved lifting procedure. Always use the vehicle’s designated jacking points.

Important: Confirm that your vehicle is the three-door Jimny Gen 4 before ordering. Inspect all mounting hardware regularly, especially after demanding off-road use.